Now that the heads are in, time to get some of this wiring and hoses reconnected. I started by reinstalling the evap system. I then plugged the fuel injectors back in on the drivers side. I reconnected the coolant temperature sensor, even though the plastic was damaged. Later I'll have to replace it completely since I really damage the plastic with the header installation. I then proceed to plug in another connector from the wiring harness into the throttle body. I route the MAF connector under the throttle body and will plug it in after the intake install. I then move over to the passenger side and plug in all of the injectors there and the last connector on the wiring harness gets plugged into the throttle body. I proceed to plug in the vacuum tube into the throttle body and tighten it down to the coolant cross pipe bolt. Next, I connect the small coolant hose from the throttle body onto the coolant cross pipe. Although I continued doing the steering rack the same day, I decided to leave that off for a video of its own.
Video link in bio
#corvettec5 #corvette #vette #ls1