“Clearly Better Then The Rest”
We collect #Kief, make #Bubble & #Trim flowers... all with the help of #Co2. We inject liquid CO2 into the center of our #resinator chamber which let's us reduce temperatures to below -85° Fahrenheit. This allows us to instantly freeze, fracture & #extract #trichomes and resin glands from #CURED & #UNCURED flowers and plant material. We achieve 20-40% returns in as little as 2-20 minutes! ———
Trim a pound per minute! When you load your machine with #flower, you can inject liquid #Co2 into the chamber and achieve very cold temperatures. This allows the exterior leaves to become just brittle enough to fracture off of the flower and fall through the mesh screen without damaging, bruising or compromising the integrity of the flower. When #trimming with CO2 we recommend “ice-cream” temperature. That’s between 10°F and 30°F. When prepared properly, we often experience results that exceed our expectations. The better #bucked and #bigleaved your material, the less time necessary to achieve desired results, only adding to increased processing times and production volume. As a trimmer, the #OG model has a 1.5 lb capacity while the #XL model has a 7 lb capacity. If you load 5-7 pounds, then you spin for 5-7 minutes. This is a guideline, as not all flowers are created equal. Often only 30 seconds per pound is optimal, this of course is directly related to how well the product has been prepped. Refer to our #Extraction Guide http://www.theoriginalresinator.com/category-s/215.htm for suggested run times, speeds, and load sizes. The #wholebodied, #highquality #trim that remains after CO2 separation is preferred over #scissored or #bladed trim due to the lack of #chlorophyl and plant particulates found through trimmed clippings as a result of utilizing a bladed surface, making for better #extracts anyd #pre-rolls. Experience the #Resinator difference…!