k45welding@k45welding

Dime layer... ink lover... "quality is doing it right when no ones looking ."

126 posts 2,430 followers 300 following

Needed a positioner today, so welded a 7/16 socket to the drive pulley, then wrapped the drill with a hoss clamp with a tacked on washer to make the speed adjustable#redneckturntable

Sidney BC
2

Still needs to be beveled , champfered and debured. I'm always amazed at how many hours can go into fabricating something... even this small custom return has up to 3-4 hours.. good things take time#fabrication#fabricationlife#machining#weldlife

Saanichton
1

Outside edge to seal up bottom of this best of a boat! First took 3/32 rod to lay in smaller bead with complete seal then took a 1/8 rod over top to make sure there was a complete full seal with 3/16" penetration on both bottom plate and side hull of boat#fabricationlife#aliminumfabrication

Saanichton
3

Little pre hear to get them beads to lay in nice with that 1/2" plate..... loving another fab Friday!!!!#weld#welder#welding#weldporn#weldnation#weldnationarmy#pointonepercenter#fabricationlife#canadianmade

Victoria, British Columbia
2

Loading...